TOCII CA72TOC Technical Data
Endress+Hauser 133
10.4 Performance characteristics
10.5 Environment
10.6 Process
10.7 Mechanical construction
In accordance with ISO 15839
The performance characteristics have been determined in accordance with ISO 15839, Annex B. 300 μl sample were
metered into the TOCII (CA72TOC-B1A0B1) per measurement. This resulted in a measuring range from 4 to 800 mg/l.
The following data refer to this device.
Slight deviations should be factored in if applying the performance characteristics to other measuring ranges.
LOD (limit of detection) 0.75 % of end of measuring range
LOQ (limit of quantitation) 2.5 % of end of measuring range
Short-term drift 0.5 %/day
Repeatability precision at 20 % of the measuring range 0.4 %
Resolution limit at 20 % of the measuring range (LDC) 1.1 %
Systematic measured value deviation at 20 % of the measuring range (BIAS) 0.4 %
Repeatability precision at 80 % of the measuring range 1.6 %
Resolution limit at 80 % of the measuring range (LDC) 4.6 %
Systematic measured value deviation at 80 % of the measuring range (BIAS) 2.4 %
Ambient temperature
range
5 to 35 °C (41 to 95 °F)
Humidity 10 to 90 %, non-condensing
Degree of protection IP 54
Sample temperature 0 to 40 °C (32 to 104 °F)
Sample flow rate 20 ml/min (0.32 US gal/hr)
Sample feeder volume 90 ml (3 fl.oz)
PA-2, PA-3 and PA-9 are available for selection as sample preparations.
Sample consistency Aqueous
Flammable substances should not occur in combustible concentrations - sample dilution is
then necessary.
Sample supply Non-pressurized infeed to the analyzer from sample preparation.
Weight Approx. 75 kg (165 lbs)
Material Housing Aluminum, powder-coated (RAL7035)
Window Glass, conductive coating
Valve seals EPDM, FPM, FFKM
Pump hoses Ismapren
Pumps and pump seals PTFE, FFKM
Reagent and sample hoses PTFE, PE
Exhaust gas and ventilation hoses PTFE, PE
Outflow hoses PTFE
To Next Page
Loading...
