Commissioning TOCII CA72TOC
34 Endress+Hauser
6.3 Programming mode
You configure the operating parameters of the analyzer in the programming mode.
1. Press the programming key.
2. Enter the "code". The code is a four-digit number which you can find on the code card supplied
with your analyzer.
3. Press the [E] key.
The following menu appears:
a0012583-en
Fig. 14: "Programming" menu
The operating parameters are stored in the analyzer and are retained in the event of a software
update.
Within the menu items, pressing the [<] key takes you back to the "Programming" menu.
!
Note!
The operating parameters are not retained if you select SET DEFAULTS or if the CPU has to be
replaced. For this reason, make a note of the operating parameters.
SETTING
LISTS
PROGRAMMING
TEST
RANGE DATA
SET CLOCK
ALARM LIMITS
BASIC DATA
SET DEFAULTS
MEASURING SITE
To Next Page
Loading...
