Endress+Hauser TOCII CA72TOC - Operation During Measuring Mode

Operation TOCII CA72TOC
30 Endress+Hauser
5.3 Operation during measuring mode
The analyzer has three operating modes:
•Measuring mode
•Service mode
• Programming mode
The measuring mode is fully automated. Manual intervention on the part of the user is not possible.
a0012443
Fig. 11: Display during measuring operation
1Time
2 Load curve of the past 6 hours
3Timeframe
4 Measured value
5 Measured value of the IR detector
5.3.1 Recording mode
Pressing the U key during measuring operation takes you to the recording mode. Using the arrow
keys, scroll between the measured values recorded:
• V 1 day earlier
• W 1 day later
• U 2 hours earlier
• T 2 hours later
Once you have selected the required period, press the Enter key.
Recording period
• 14 days for one-channel operation
• 7 days for two-channel operation
5.3.2 Spot view
The spot view is activated in the recording mode by pressing the Enter key.
The following information is displayed:
• Load curve
•Measured value
•Date
•Time
A small cursor on the display indicates where you are currently in the load curve.
TOC
mg/l
IR = 334 ppm
234
5
00
6
00
7
00
8
00
9
00
10
00
11
00
1000
500
11:39:04
1
2
3
45