Endress+Hauser TOCII CA72TOC - Entering the Concentration of the Standard Solution; Service Software

Maintenance TOCII CA72TOC
62 Endress+Hauser
7.5 Entering the concentration of the standard solution
This section describes how the concentration of the standard solution is entered.
Select the programming mode for this purpose:
7.6 Service software
The maintenance tasks are supported by the service software. This software is split into four
sections:
Step Display Description
1
2 • Enter the values for STANDARD C1
and STANDARD C2.
Pumps Replace hose P1/4
Pump 2 replace hose
Pump 3 replace hose
Calibrate pump 2
Calibration Analyzer adjustment
Analyzer calibration
Empty volume dosing
Adjustment pH sensor
Cleaning Screen flush
Power-flush
Bypass-screen
Stripper + separation
Open gas circuit
Combustion pipe
Leakage test
Filters Replace acid filter
Replace gas filters
Replace O2-filter
Replace heated filter
SETTING
LISTS
PROGRAMMING
TEST
RANGE DATA
SET CLOCK
ALARM LIMITS
BASIC DATA
SET DEFAULTS
MEASURING SITE
:
:
:
:
:
:
:
:
:
:
:
:
[sec]
[ml/min]
[ml/min]
[ul]
1000.00
0.00
0.00
0.00
0.00
7.50
18.60
300.00
80.00
720.00
3.00
2.00
RANGE DATA
SCALE
FLUSH SCREEN/DAY
POWER-FLUSH/DAY
DAYBREAK
PAUSE CYCLE
P1 (B)
P4 (B)
BATCH VOL.
STANDARD C1
STANDARD C2
CALIBRATION n DAY
CAL./ADJUSTMENT