Endress+Hauser TOCII CA72TOC - Page 47

TOCII CA72TOC Commissioning
Endress+Hauser 47
Settings for the analog outputs
You must enter the following parameters in the Basic Data menu:
PROGRAMMING/SETTING/BASIC DATA:
Settings for the alarm limits
You must enter the following parameters in the ALARM LIMITS menu:
PROGRAMMING/SETTING/ALARM LIMITS:
All the alarm limits affect the same signal output II (binary out II). A limit value alarm is also retained
following channel switchover until the limit value for the channel in question is undershot.
Parameter Unit Description
SCALE AO CH1 Scale end value of the analog output of channel 1.
SCALE AO CH2 Scale end value of the analog output of channel 2.
Parameter Unit Description
HI ALARM LIMIT CH1 mg/l Use this function to specify the alarm value for when the value for
channel 1 is overshot.
LO ALARM LIMIT CH1 mg/l Use this function to specify the alarm value for when the value for
channel 1 is undershot.
HI ALARM LIMIT CH2 mg/l Use this function to specify the alarm value for when the value for
channel 2 is overshot.
LO ALARM LIMIT CH2 mg/l Use this function to specify the alarm value for when the value for
channel 2 is undershot.