THIS DOCUMENT CONTAINS CONFIDENTIAL INFORMATION PROPRIETARY TO ENERGATE INC. NO PART OF ITS CONTENTS MAY BE DISCLOSED OR CONVEYED TO,
USED BY, OR COPIED TO A THIRD PARTY WITHOUT PRIOR WRITTEN CONSENT BY ENERGATE INC. PRINTED COPIES WILL BE CONSIDERED UNCONTROLLED.
AW000873-G 57
5. On the Create Single Text Message page, enter the configuration and text for a message:
Start Time: Select Immediate if you are ready to test the thermostat. To delay the message, select Date/Time
and select a time in the future.
Duration: Specify how long the message is displayed on the thermostat screen in hours and minutes.
Display for Smart Device: Enter a message of up to 241 characters to display on the screen.
Confirmation Required: Select if the utility requires confirmation that the user has acknowledged the message.
6. Click Submit.
LMS sends a full-screen message to the thermostat. The user presses the Menu/Select button to clear and
acknowledge it.
If you selected Confirmation Required, notification that the message was acknowledged is sent to LMS and stored
in the message information. For information on viewing messages, see the Load Management System Guide.
To Next Page
Loading...
