enraf Ensite Pro - Configure Tanks - Roof; Roof Configuration and Zone Settings

Configure tanks
Instruction manual Ensite Pro Configuration Tool Page 35
High/low zones
The program will issue a warning if the low value is higher than the
high value.
Roof
Zone 1 Enabled Check to enable
No GOV calculation Check to disable volume calculation when level is in zone 1
No Water Volume calculation
Check to disable
Weight Enter roof weight
High Enter no-go-zone 1 high level
Low Enter no-go-zone 1 low level
Zone 2
Enabled Check to enable
No GOV calculation Check to disable volume calculation when level is in zone 2
No Water Volume calculation
Check to disable
Extra Weight Enter roof weight
High Enter no-go-zone 2 high level
Low Enter no-go-zone 2 low level