Enterasys SecureStack C2 C2G124-48P - Chapter 1: Introduction; Overview

SecureStack C2 Installation Guide 1-1
1
Introduction
ThischapterintroducestheC2G124‐48PandC2H124‐48PGigabitEthernetstackable
switches.
Overview
TheC2G124‐48PandC2H124‐48Parestackableswitchesthatcanbeadaptedandscaled
tohelpmeetyournetworkrequirements.Theseswitchesprovideamanagementplatform
andanuplinktoanetworkbackboneforastackedgroupofuptoeightC2switches.
Theswitchesalsosupporttheuseof
aredundantDCpowersupplytohelpprevent
downtimeduetoaninternalpowersupplyfailureintheswitchorACpowersource.
Youcaninstalltheswitch
onaflatsurfaceorintoastandard19‐inchrackwithuser‐
suppliedmountinghardware,andconfiguretheswitchfunctionsusingtheWebView™
application,CLIswitchingcommands,and/orSNMP.
Important Notice
Depending on the firmware version used in the switch, some features described in this document
may not be supported. Refer to the Release Notes shipped with the switch to determine which
features are supported.
For information about... Refer to page...
Overview 1-1
PoE (Power over Ethernet) Support 1-5
Connectivity 1-6
Management 1-6
Standards Compatibility 1-7
LANVIEW Diagnostic LEDs 1-7
Getting Help 1-7