Enterasys SecureStack C2 C2G124-48P - Connecting to a Modem; Connecting a VT Series Terminal

Connecting to Console Port for Local Management
3-20 Hardware Installation
Figure 3-11 Connecting a VT Series Terminal
Connecting to a Modem
ToconnectamodemtoanEnterasys Networksswitchmodemport(Figure 3‐12),usea
UTPcableterminatedwithaDB9femaleconnectorandaDB25maleconnector,and
proceedasfollows:
1. ConnecttheDB9female connectoratoneendofthecabletotheConsoleportonthe
Enterasysswitch.
(IfthereisaswitchdesignatedastheManager,connecttoits
Consoleport.)
2. PlugtheDB25maleconnectorattheotherendofthecableintothemodem
communicationsport.
3. TurnonthemodemandmakesuretheremotemodemisON.
4. WithyourPCconnectedtotheremotemodem,configure
yourVTemulationpackage
withthefollowingparameters:
1 DB9 female cable connector 4 DB25 female connector
2 Serial interface cable 5 PC with VT emulation application
3 DB9 male Console port connector
C2G124-24
Console
45
46
47
48
C2G124-48P
45 46
47
48
ÂÃ
Á
À
Ä
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit