Enterasys SecureStack C2 C2G124-48P - Switch Configuration Using CLI Commands; Standards Compatibility; LANVIEW Diagnostic Leds; Getting Help

Standards Compatibility
SecureStack C2 Installation Guide 1-7
Switch Configuration Using CLI Commands
TheCLIcommandsenableyoutoperformmorecompleteswitchconfiguration
managementtasks.
ForCLIcommandsetinformationandhowtoconfigurethemodule,refertothe
SecureStackC2ConfigurationGuide.
Standards Compatibility
TheswitchesarefullycompliantwiththeIEEE802.3‐2002,8 02.3ae‐2002,802.3af‐2002,
802.1D‐19 98,and802.1Q‐1998standards.TheswitchesprovideIEEE802.1D‐1998
SpanningTreeAlgorithm(STA)supporttoenhancetheoverallreliabilityofthenetwork
andprotectagainst“loop”conditions.
LANVIEW Diagnostic LEDs
LANVIEWdiagnosticLEDsserveasanimportanttroubleshootingaidbyprovidingan
easywaytoobservethestatusofindividualportsandoverallnetworkoperations.
Getting Help
Foradditionalsupportrelatedtothemoduleorthisdocument,contact
Enterasys N etworksusingoneofthefollowingmethods:
BeforecontactingEnterasys Networksfortechnicalsupport,havethefollowing
informationready:
•YourEnterasys Networksservicecontractnumber
•Adescriptionofthefailure
World Wide Web http://www.enterasys.com/services/support
Phone 1-800-872-8440 (toll-free in U.S. and Canada)
For the Enterasys Networks Support toll-free number in your country:
www.enterasys.com/services/support/contact/
Internet mail support@enterasys.com
To expedite your message, please type [SWITCHING] in the subject line.
To send comments or suggestions concerning this document to the Technical Publications
Department:
techpubs@enterasys.com
To expedite your message, please include the document Part Number in the email message.