Enterasys SecureStack C2 C2G124-48P - Page 71

Using the Reset Button
SecureStack C2 Installation Guide 4-9
Toresettheswitchpassword,referbacktoFigure 4‐3andproceedasfollows:
1. Press‐and‐holdtheResetbuttonwhiletheswitchisoperational.Thischangeofthe
loginpasswordtothedefaultpasswordwillbeindicatedthroughCLIonly.
2. Logontodevicemanagement.Youcannowlogontotheswitch
throughtheConsole
portandassignanewpasswordusingthecommandlineinterface(CLI).
3. ToaccessswitchmanagementfromyourlocalPC,terminal,ormodemconnection,
refertotheSecureStackC2ConfigurationGuideforinstructionsonhowtologinand
enteranewpassword.Theguideisavailable
at:
http://www.enterasys.com/support/manuals
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed
in“GettingHelp”onpage 1‐7.
Note: Notify the system manager before changing the password.