Envision One cDLM® User Manual
TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15
The oxygen delivery tube connects from the front of the oxygen concentrator to the back of the Envision One.
Firmly insert the open end of the tube into the plastic release ring at the back of the printer.
The concentrator should stay on during printer operation. It can be turned off when the printer is
not in use. When turning the concentrator back on, wait 30 minutes for the oxygen to prime.
7.6 Setting the Ethernet
To connect the printer to your network, proceed as follows:
1. Plug the Ethernet cable into the network connector located on the back of the printer.
2. Connect the Ethernet cable to your network.
3. On the main screen of Control Software, tap Settings | Ethernet.
There are two types of Connection: static and dynamic.
Dynamic connection or DHCP – printer gets the dynamic IP address. All the fields are greyed out.
4. To set the Static connection, all the fields need to be filled manually.
7.7 Setting WI-FI
To set Wi-Fi on the printer, proceed with the following steps:
1. Enter the WI-FI tab by tapping Settings | Wi-Fi on the touch screen.
2. On the left part of the screen, select the required Wi-Fi name and tap it.
3. Tap [Join].
4. In the Password field, type a password for the selected Wi-Fi.
5. Tap [OK].
To Next Page
Loading...