Envision One cDLM® User Manual
TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15
8.10 Manual Debris Removal Tab
This tab allows the user to simplify the process of cleaning the material tray.
To remove debris from the material tray, proceed as follows:
1. Tap Settings | Manual Debris Removal to open the tab.
To learn more about this feature, click on the ? icon in the upper-
right corner of the screen. Scan
the QR-code with your mobile phone or tablet to visit the corresponding page
in the online
knowledge base.
2. Set the required exposure time using the + and – icons.
3. Tap [Expose].
→ The whole material tray area is exposed.
4. Remove debris from the material tray by lifting the thin film of exposed material.
5. Proceed following the step-by-step for Filtering Material, if needed.
Job List Menu
Tap [Job List] on the main screen of the Control Software to open the tab.
Scroll through the list to view different jobs. There is the following information on job statistics:
• Layer thickness – the thickness of one layer in µm.
• Layers – the number of layers for the job.
• Print time – the estimated time when the job will finish. This calculation is approximate and is updated
dynamically after each exposure.
• Status – the state of the job at a current time. It can be:
• New – if the job has not been printed yet.
• Complete – if the job has been printed successfully.
• Failed – if the job has corrupted or failed due to material mismatch.
• Aborted – if the job has been aborted manually or cancelled due to mechanical issues (projector/board
does not respond, etc.)
• Invalid – if a problem is detected when transferring the job file from Envision One RP® to Envision One
Control Software
To Next Page
Loading...