Epson AcuLaser C3900N - Page 127

Item Description
Range of IP address
permitted access*
Specify the range of IP addresses permitted access to the printer. Type the IP address at the
beginning of the range into the box on the left, and the IP address at the end of the range
into the box on the right.
Range: 0-255 for each xxx triplet
Default: 0.0.0.0
Note:
❏ To specify a single IP address, type the same IP address into both the box for the
starting IP address and for the ending IP address, or type “0.0.0.0” into the box for
either the starting IP address or the ending IP address.
❏ If the starting IP address is larger than the ending IP address, the setting is not applied.
Access Refuse Address
If Enable is selected, the range of IP addresses refused access to the printer can be
specified.
A maximum of five ranges of refused IP addresses can be specified.
Choices: Enable, Disable
Default: Disable
Configuration Menu Equivalent:
INTERFACE MENU - ETHERNET - TCP/IP - IP ADDRESS FILTER - ACCESS REFUSE
Range of IP address
refused access*
Specify the range of IP addresses refused access to the printer. Type the IP address at the
beginning of the range into the box on the left, and the IP address at the end of the range
into the box on the right.
Range: 0-255 for each xxx triplet
Default: 0.0.0.0
Note:
❏ To specify a single IP address, type the same IP address into both the box for the
starting IP address and for the ending IP address, or type “0.0.0.0” into the box for
either the starting IP address or the ending IP address.
❏ If the starting IP address is larger than the ending IP address, the setting is not applied.
Apply button Applies the configuration settings in this page.
Clear button Resets all configuration settings to previous values.
*
Always enter these addresses without leading zeros. For example, 131.011.010.001 should be entered as 131.11.10.1.
AcuLaser C3900 Reference Guide
Using Web-Based EpsonNet Config 127