Item Description
TCP/IP Sets whether or not to use TCP/IP.
Choices: Enable, Disable
Default: Enable
Configuration Menu Equivalent:
INTERFACE MENU - ETHERNET - TCP/IP - ENABLE
Speed Specifies the operating mode and speed for Ethernet.
Choices: Auto, 10Base-T (Half), 10Base-T (Full), 100Base-TX (Half), 100Base-TX (Full),
1000Base-T (Full)
Default: Auto
Configuration Menu Equivalent:
INTERFACE MENU - ETHERNET - SPEED/DUPLEX
LPD Select whether or not LPD is used.
Choices: Enable, Disable
Default: Enable
SLP Select whether or not SLP is used.
Choices: Enable, Disable
Default: Enable
Configuration Menu Equivalent:
INTERFACE MENU - ETHERNET - TCP/IP - SLP - ENABLE
LLMNR Select whether or not LLMNR is used.
Choices: Enable, Disable
Default: Enable
Apply button Applies the configuration settings for this window.
Clear button Resets all configuration settings to previous values.
IPv4 Settings
For more information on these TCP/IP, see Chapter 4 “Network Printing ” on page 49.
AcuLaser C3900 Reference Guide
Using Web-Based EpsonNet Config 121
To Next Page
Loading...
