Default Settings
General Settings
Item Description
PDL Indicates default language to be selected.
Paper Source The paper tray that is normally used is indicated.
Duplex
If Long-Edge Binding is indicated, the pages will be printed on both sides of the
paper for long-edge binding.
If Short-Edge Binding is indicated, the pages will be printed on both sides of the
paper for short-edge binding.
Output Tray Displays the name of the output tray.
Copies Indicates the default setting for number of copies to be printed.
Paper Size Indicates the default setting for the size of paper.
Width
Indicates the paper width when Paper Size is set to Custom Size.
Length
Indicates the paper length when Paper Size is set to Custom Size.
Paper Type Indicates the default setting for the type of paper.
Collate
If On is indicated, all pages in a copy of the document can be printed before
printing the next copy.
If Off is indicated, all copies of the document are not printed separately.
Note:
This menu item appears only if an optional hard disk drive is installed.
Unit of Measure The units for specifying the size of custom paper is indicated between inches and
millimeters.
Paper Source Settings
Item Description
Tray1 Paper Size Indicates the setting for the size of paper loaded into Tray1.
Width
Indicates the paper width when Paper Size is set to Custom
Size.
Length
Indicates the paper width when Paper Size is set to Custom
Size.
Paper Type Indicates the setting for the type of paper loaded into Tray1.
AcuLaser C3900 Reference Guide
Using Web-Based EpsonNet Config 78
To Next Page
Loading...
