Epson AcuLaser C3900N - Ca Certificate Information

Item Description
Send Client Certificate Select whether or not the client certificate is sent when the client certificate is
requested by the server. Specifies the send client certificate, when EAP Type is set
to EAP-TTLS or PEAP.
Choices: Enable, Disable
Default: Disable
Client Certificate Shows whether or not a client certificate has been specified.
Note:
Specify the settings from the Network - SSL/TLS page.
CA Certificate Shows whether or not a CA certificate has been specified for CA reliability
verification of server certificates.
Note:
Specify the settings from the Network - Authentication - CA Certificate page.
Server ID Specify the characters for verification through backward matching with the CN
attributes of the server certificate. Specifies the server ID, when EAP Type is set to
EAP-TLS, EAP-TTLS, or PEAP.
Range: Up to 64 characters
Encryption Strength Specify the encryption level of TLS packets with EAP-TLS/TTLS/PEAP. Specifies
the encryption strength, when EAP Type is set to EAP-TLS, EAP-TTLS, or
PEAP.
Choices: Low, Medium, High
Default: Low
Limit Time of Network Stop Specify the length of time to postpone stopping the network when
authentication fails from the start of authentication.
Range: 0, 60 - 255 (seconds)
Default: 0
Apply button Applies the configuration settings for this window.
Clear button Resets all configuration settings to previous values.
CA Certificate
CA Certificate Information
Note:
As a default, CA Certificate is not installed. Click Setting to create a certificate and specify the CA
Certificate settings.
AcuLaser C3900 Reference Guide
Using Web-Based EpsonNet Config 150