Epson AcuLaser CX17 Series User Manual

10. Print a System Settings page from the operator panel.
See “Printing a System Settings Page” on page 149.
11. Confirm that “Link Quality” is shown as “Good”, “Acceptable” or “Low” on the report.
Note:
When “Link Quality” is “No Reception”, check if the wireless settings are correctly configured.
WPS-PIN
Note:
❏ WPS-PIN is a method to authenticate and register devices required for wireless configuration, by
entering PIN code to a printer and computer. This setting, performed through access point, is
available only when the access points of your wireless router supports WPS.
❏ Before WPS-PIN starts, you will need to enter your PIN code at the web page of the wireless access
point. See the access point manual for the details.
1. On the operator panel, press the System button.
2. Select Admin Menu, and then press the
button.
3. Select Network, and then press the
button.
4. Select Wireless Setup, and then press the
button.
5. Select WPS, and then press the
button.
6. Select PIN Code, and then press the
button.
7. Take a note of PIN code displayed on the operator panel.
8. Select Start Configuration, and then press the
button.
9. If SSID selection screen appears, select the SSID, and then press the
button.
10. Enter the PIN code of the printer at the web page of the wireless access point.
11. Wait a few minutes until the printer restarts to establish the wireless network.
12. Print a System Settings page from the operator panel.
Epson AcuLaser CX17 Series User’s Guide
Printer Connection and Software Installation 107

Epson AcuLaser CX17 Series Specifications

General

Brand	Epson
Model	AcuLaser CX17 Series
Category	Printer
Language	English