Epson AcuLaser CX17 Series User Manual

Note:
This item is displayed only when the printer is connected with a wireless network.
TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then
on.
Values:
IP Mode Dual Stack*
Uses both IPv4 and IPv6 to set the IP address.
IPv4
Uses IPv4 to set the IP address.
IPv4 Get IP Address DHCP/AutoIP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator panel.
IP Address
Manually sets the IP address allocated to the printer.
Subnet Mask
Manually sets the subnet mask.
Gateway Address
Manually sets the gateway address.
Note:
To configure the IPv6 settings, use EpsonNet Config.
Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and
then on.
Values:
LPD Disable
Disables the Line Printer Daemon (LPD) port.
Enable*
Enables the LPD port.
Epson AcuLaser CX17 Series User’s Guide
Using the Operator Panel Menus and Keypad 256

Epson AcuLaser CX17 Series Specifications

General

Brand	Epson
Model	AcuLaser CX17 Series
Category	Printer
Language	English