Epson AcuLaser CX17 Series User Manual

Values:
Low Power Timer 5min*
Specifies the time taken by the printer before it enters the Low Power
mode after it finishes a job.
5–30min
Sleep Timer 6min*
Specifies the time taken by the printer before it enters the Sleep mode
after it goes into the Low Power mode.
1–6min
Enter 5 in Low Power Timer to put the printer in the Low Power mode five minutes after it finishes a
job. This uses less energy, but requires more warm-up time for the printer. Enter 5 if your printer
shares an electrical circuit with room lighting and you notice lights flickering.
Select a high valu e if your prin ter is in constant us e. In most circu mstances, thi s keeps the printer ready
to operate with minimum warm-up time. Select a value between 5 and 30 minutes for the Low Power
mode if you want a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the Power Saver mode when it receives
data from the computer. In the Low Power mode, you can also return the printer to the standby mode
by pressing any button on the operator panel. In the Sleep mode, you can return the printer to the
standby mode by pressing the
(Energy Saver) button.
Auto Reset
Purpose:
To automatically reset the settings for copying, scanning, or faxing to the defaults and return to the
standby mode after you do not specify any settings for the specified time. (The fax feature is available
only on the Epson AcuLaser CX17NF/CX17WF.)
Values:
45sec*
1min
2min
3min
4min
Epson AcuLaser CX17 Series User’s Guide
Using the Operator Panel Menus and Keypad 267

Epson AcuLaser CX17 Series Specifications

General

Brand	Epson
Model	AcuLaser CX17 Series
Category	Printer
Language	English