Note:
Do not connect the printer USB cable to the USB connector available on the keyboard.
Network Connection (Epson AcuLaser CX17NF/CX17WF Only)
To connect the printer to a network:
1. Ensure that the printer, computer, and any other connected devices have been turned off and all
cables have been disconnected.
2. Connect one end of an Ethernet cable into the Ethernet port at the rear of the printer, and the other
end to a LAN drop or hub.
* Ethernet port
Note:
Connect the Ethernet cable, only if you need to setup a wired connection.
See Also:
“Configuring Wireless Settings (Epson AcuLaser CX17WF Only)” on page 57
Epson AcuLaser CX17 Series User’s Guide
Printer Connection and Software Installation 45
To Next Page
Loading...
Need help?
General