Sub-menu Function
Operation
Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cable is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When this is set to On, the power is turned
off automatically when no image signal is input and no
operation is performed within a certain amount of time.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
Trigger Out: When this is set to On, the trigger out signal
(DC 12 V) is output. External devices are then informed
whether the projector is on or off.
High Altitude Mode: Set this to On when using the
projector at an altitude of 1500 m or above.
Standby Mode
If you set Communication On, you can perform the
following operations even if the projector is in standby
mode.
• Monitoring and controlling the projector via a network.
s "Monitoring and Controlling" p.114
• Outputting images to an external monitor.
Air Filter Set-
ting
Clean Notice: When set to On, a message is displayed when
it is time to clean the air filter.
Clean Notice Timing: Set the timing for the air filter
cleaning notification.
Projector ID
Set the ID to a number between 1 and 9. Off indicates that
no ID is set.
s "Setting the Projector ID" p.52
Sub-menu Function
Multi-screen
You can adjust the hue and brightness of each projected
image when multiple projectors are lined up and projecting.
Adjustment Level: You can adjust from black to white in
five stages called Level 1 to 5, and in each of these 5 levels,
you can adjust Brightness Correct. and Color Correct.
Brightness Correct.: Corrects the difference in the
brightness of each projector.
Color Correct. (G/R) / Color Correct. (B/Y): You can
correct the difference in the color of each projector.
s "Correcting Color when Projecting from Multiple
Projectors" p.53
Language
You can set the language for messages and menus.
Reset
You can reset Display
*1
, Operation
*2
, and Air Filter
Setting from the Extended menu to their default settings.
See the following to return all menu items to their default
settings.
s "Reset Menu" p.81
*1When User's Logo Protect is set to On in Password Protect, settings related
to user's logo cannot be changed. You can make changes after setting User's
Logo Protect to Off.
s "Managing Users (Password Protect)" p.57
*2 Except for High Altitude Mode.
List of Functions
70
To Next Page
Loading...
