If the triangle in the direction you are adjusting the shape turns gray,
as shown in the screenshot below, you cannot adjust the shape any
further in that direction.
q
If you press the [Default] button while adjusting, the value that you
are adjusting is reset to the default.
E
Press the [Esc] button to return to the previous screen.
F
Repeat procedures from 3 to 5 as needed to adjust any
remaining parts.
G
When you are done, press the [Esc] button to exit the
correction menu.
q
If the [Esc] button is held down for about two seconds while
correcting with Arc Correction, the following screen is displayed.
Select "Yes" to reset the result of Arc Correction.
Adjusting the Projected Image
145
To Next Page
Loading...
