•
Mak
e sure that the access point, the computer, the mobile device and the
base unit are not too far apart. Move them closer together and try to connect
again.
•
Check for interference from other equipment, such as a Bluetooth device or
microwave. Move the interfering device farther away or expand your wireless
bandwidth.
•
Reduce the number of connected devices if the connection speed declines.
Solutions When You Cannot Connect Using Screen
Mirroring
If you are unable to connect to the base unit using Screen Mirroring, try the
fo
llowing solutions:
•
Check the base unit's settings.
•
Set the Simple AP setting to On.
s Network > Network Settings > Simple AP
•
Check the mobile device's settings.
•
Make sure the settings on the mobile device are correct.
•
When connecting again immediately aer disconnecting, it may take some
time until the connection is established. Reconnect aer waiting for a
while.
•
Restart the mobile device.
•
Once you have connected using Screen Mirroring, the base unit
connection information may be recorded on the mobile device. However,
you may not be able to reconnect to the base unit from the recorded
information. Select the base unit from the list of available devices.
g
Related Links
•
"Network Menu - Network Settings Menu" p.89
•
"Network Menu - Network Projection Settings" p.92
Solutions When You Cannot Use Two Screen Mirroring
Sources
If you are unable to use two Screen Mirroring sources at the same time, set the
In
terrupt Connection setting to O.
s Network > Network Settings > Network Projection > Screen Mirroring
g
Related Links
•
"Network Menu - Network Projection Settings" p.92
Solutions When the Image or Sound Contains Static
During Screen Mirroring Connection
If the displayed image or sound contains static when connecting using Screen
M
ir
roring, try the following solutions:
•
Avoid covering the Wi-Fi antenna of the mobile device.
•
If you use a Screen Mirroring connection and an internet connection at the
same time, the image may stop or contain noise. Disconnect the internet
connection to expand your wireless bandwidth and improve the connection
speed of the mobile device.
•
Make sure the display contents meet the Screen Mirroring requirements.
•
Depending on the settings of the mobile device, the connection may be lost
when the device enters power saving mode. Check the electrical power saving
settings on the mobile device.
•
Update to the latest version of the wireless driver or rmware on the mobile
device.
Solving Network Problems
113
To Next Page
Loading...
Need help?
General
