Epson ELPWP10 User Manual

Aer selecting the base unit's menu settings for one base unit, you can use the
f
ollowing methods to copy the settings to other base units, as long as they are
the same model.
•
by using a USB ash drive
•
by connecting a computer and base unit using a USB cable
You cannot copy any information unique to an individual base unit, such as
Operation Hours or Status.
Make sure Batch S
etup Range is set to Limited if you do not want to copy
the following settings:
•
Password Protection settings
•
Network menu settings
s Management > Batch Setup Range
Caution
Eps
on takes no responsibility for batch setup failures and associated repair costs due
to power outages, communication errors, or other problems that may cause such
failures.
g
Related Links
•
"T
ransferring Settings From a USB Flash Drive" p.95
•
"Transferring Settings From a Computer" p.96
Transferring Settings From a USB Flash Drive
You can copy menu settings from one base unit to another of the same model
usin
g a USB ash drive.
•
e USB
ash drive must use a FAT16/32 format and not incorporate
any security function. Delete any les on the drive before using it for
batch setup or the settings may not be saved correctly.
•
You can also use this batch setup method from the base unit's menu.
a
Disconnect the AC adapter from the base unit, and check that base unit's
indic
ator has turned o.
b
Connect an empty USB ash
drive directly to the base unit's USB-A port.
c
Hold down the [Esc] button on the remote control and connect the AC
adap
ter to the base unit.
d
When the base unit's indicator turns on, release the [Esc] button.
e indic
ators start ashing and the batch setup le is written to the USB
ash drive. When writing is nished, the base unit turns o.
Caution
Do not disconnect the AC adapter or the USB ash drive from the base
unit while the le is being written. If the AC adapter or USB ash drive is
disconnected, the base unit may not start correctly.
e
Remove the USB ash
drive.
e le name for the batch setup le is PJCONFDATA.bin. If you
n
eed to change the le name, add text aer PJCONFDATA using
only alphanumeric characters. If you change the PJCONFDATA
section of the le name, the base unit may not be able to recognize
the le correctly.
f
Disconnect the AC adapter from the base unit to which you want to copy
s
et
tings, and check that the base unit's indicator has turned o.
Copying Menu Settings Between Base Units (Batch Setup)
95

Epson ELPWP10 Specifications

General

Brand	Epson
Model	ELPWP10
Category	Projector Accessories
Language	English