EasyManuals Logo

Epson RC700-A User Manual

Epson RC700-A
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #188 background imageLoading...
Page #188 background image
Maintenance 9. Troubleshooting
176 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
1001
Operation Failure.
Command parameter is invalid.
-
1002
Requested data cannot be
accessed. The data is not set up
or the range is invalid.
Check whether the target I/O,
variables, and tasks exist.
1003
The password is invalid
Enter the correct password.
1004
Cannot execute with unsupported
version.
Use the correct version file.
1005
Cannot execute with invalid serial
number.
Use the backup data for the same
controller to restore the controller
configuration.
1006
Cannot execute with invalid Robot
model.
Use the backup data for the same
controller to restore the controller
configuration.
1007
Cannot execute with invalid
Controller.
Use the supported installer.
1010
Remote setup error.
Cannot assign R-IO input number
to remote input.
Specify the input number excluding
the R-IO input number.
1011
Remote setup error.
Cannot assign a bit number which
does not exist to a remote I/O
signal.
Check the fieldbus slave size.
Check the fieldbus slave size.
1012
Remote setup error.
Cannot assign a bit number which
does not exist to a remote I/O
signal.
Check the fieldbus master size.
Check the fieldbus master size.
1013
Fieldbus slave failure.
Cannot change the size because it
currently includes a remote I/O
signal.
-
1014
Fieldbus master failure. Cannot
change the size because it
currently includes a remote I/O
signal.
-
1015
Remote setup error. Cannot assign
Hand-IO input/output number to
remote input.
-
1020
Cannot execute in recovery mode.
Boot the controller as normal.
1021
Cannot execute due to controller
initialization failure.
Restore the controller configuration.
1022
Cannot execute without the project
being open.
Open a project.
1023
Cannot execute while the project is
open.
Rebuild the project.
1024
Cannot activate from remote.
Enable the remote input.
1025
Execution in Teach mode is
prohibited.
Change to the AUTO mode.
1026
Cannot execute in Teach mode
except from TP.
Change to the AUTO mode.
1027
Cannot execute in Auto mode.
Change to the Program mode.
1028
Cannot execute in Auto mode
except from the main console.
Change to the Program mode.
1029
Cannot execute from OP.
Enable the OP input.

Table of Contents

Other manuals for Epson RC700-A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson RC700-A and is the answer not in the manual?

Epson RC700-A Specifications

General IconGeneral
BrandEpson
ModelRC700-A
CategoryController
LanguageEnglish

Related product manuals