Epson RC90 User Manual

2. Installation
RC700 / RC90 Option Fieldbus I/O Rev.14 217
*1: Remote control inputs and outputs are not allocated to fieldbus slave I/O by default.
To allot remote control input and output to fieldbus slave I/O, refer to 3.5 Setting
Remote Control Input and Output later in this manual.
*2: When initialization of the CC-Link module is completed at the Robot system turn-on,
Remote Ready flag [RX(n+5)B] turns ON.
I/O assignment of Remote Ready cannot be changed or disabled (NA).

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English