EasyManuals Logo

Epson SC-F9200 series Service Manual

Epson SC-F9200 series
412 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
SC-F9200 Series Revision C
TROUBLE SHOOTING Remedies for Service Call Error 58
SE Group Confidential (Related Staff Only)
1FC0
CSIC error CSIC control error
---
1. Replace the Ink Holder.
(Page 183, 189)
2. Replace the Main Board. (Page 123)
1FC1
CSIC error CSIC control error
---
1. Replace the Ink Holder.
(Page 183, 189)
2. Replace the Main Board. (Page 123)
2000
NVRAM error NVRAM erase or write error has occurred.
---
Replace the Main Board.
(Page 123)
2002
SDRAM error
Writing to the SDRAM was attempted, but nothing
could be written to it.
--- Replace the Main Board. (Page 123)
2003
FLASH BOOT
checksum error
Installing the firmware has failed.
The Flash ROM is out of order.
---
1. Re-install the firmware. (Page 291)
1. Replace the Main Board. (Page 123)
200A
F/W load error Reading/decompressing the firmware has failed.
---
1. Re-install the firmware.
(Page 291)
1. Replace the Main Board. (Page 123)
200D
System interrupt
watchdog time-out
error
A system failure such as CPU failure, or defective
cash has occurred.
---
Replace the Main Board.
(Page 123)
3000
AC shut-off
The AC power has been shut off due to a power
failure, unplugged, Power Supply Board failure, or
Main Board failure or the like.
Is the Power cable properly connected?
1. Replace the Power Supply Board.
(Page 125)
2. Replace the Main Board. (Page 123)
Dxxy
Service call for FW
debugging
This error is intended to be used in the product
development stage. It is supposed to not occur with
marketed product, but may occur due to an
unexpected cause such as external noises.
Turn the power off and back on. Does the printer
recover from the error? (No repair work is needed
unless the error occurs again.)
1. Re-install the firmware.
(Page 291)
2. Replace the Main Board. (Page 123)
Fxxx
CPU related service
call
There is something wrong with the firmware.
The Main Board is out of order.
Is the firmware installed correct one for the printer?
1. Re-install the firmware. (Page 291)
2. Replace the Main Board. (Page 123)
Table 2-4. Troubleshooting for Service Call Error
Code Error Name Cause Check Item Remedy

Table of Contents

Other manuals for Epson SC-F9200 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson SC-F9200 series and is the answer not in the manual?

Epson SC-F9200 series Specifications

General IconGeneral
BrandEpson
ModelSC-F9200 series
CategoryPrinter
LanguageEnglish

Related product manuals