Epson Stylus Color 1160 - Page 109

EPSON Stylus COLOR 860/1160 Revision C
Disassembly and Assembly Disassembly Procedures 109
5) Remove the CR Encoder Board Assembly from the CR Frame as shown in
Figure 4-53.
Figure 4-53. Removing the CR Encoder Board Assy.
6) Remove the CR Timing Belt from the gutter in the CR Frame.
Figure 4-54. Assembling the I/C Detector Lever
Figure 4-55. Placing the I/C Detector Cables
CHECK
POINT
n Make sure that the Torsion Spring 1.08 is hung onto
the protrusion of the I/C Detector Lever and the
hook on the CR frame correctly. Refer to Figure
4-54.
n Ensure that the I/C Detector Cables are placed
along the gutters as Figure 4-55.
n Make sure that the I/C Detector Lever acts correctly.
CR Assembly
CR Encoder Board Assembly
Torsion Spring 1.08
Hanging portion
Hanging portion
Torsion Spring
I/C Detector