Epson Stylus Color 1160 - Choose the Model

EPSON Stylus COLOR 860/1160 Revision C
Adjustment Adjustment 126
5.2.3.3 Choose the Model
1. Before performing any adjustment, you need to choose the Model
Name. When you click the OK button after choosing the model
name, the adjustment program sends the factory command to the
printer in order to set the IEEE1284-4 mode to OFF status. This is
because this program dose not run in the IEEE1284-4 mode.
Figure 5-9. Main menu of the Program
NOTE: When the OK button is pressed in the above menu, this
adjustment program dose not verify the model name stored
in the PROM.
NOTE: IEEE-1284-4 mode is reset to ON status by performing the
Hardware reset.
NOTE: When you choose the “About” and click it, the program
version is shown.