EPSON Stylus COLOR 860/1160 Revision C
Disassembly and Assembly Disassembly Procedures 87
4.2.4.2 Removing the Waste Ink Absorber Tray Assembly
1. Remove the Upper Housing. (Refer to Section 4.2.1.)
2) Remove one screw (No.1) securing the Left Housing Panel to the Printer
Mechanism. Refer to Figure 4-9.
3) Remove two screws (No.1) securing Left Sub Frame and remove Left Sub
Frame. Refer to Figure 4-9.
Figure 4-9. Removing the Left Housing Panel &Left Sub Frame
4) Insert a screw driver through the center hole in the Paper Eject Assembly
and remove one screw (No.3) securing the Lower Paper Support Front to
the Waste Ink Absorber Tray Assembly.
Refer to Figure 4-10.
5) Inserting a screw driver through the cutout, remove No. 3 screw* securing
Waste Ink Absorber Tray Assembly to the right bottom part of the
mechanism. Refer to Figure 4-10.
* One screw for SC860 and two screws for SC1160
6) On the Left side of the printer mechanism, using tweezers or a small screw
driver, carefully shift the Tray Spacer securing the Waste Ink Absorber
Tray Assembly to left horizontally. Refer to Figure 4-10.
7) Remove the Waste Ink Absorber Tray Assembly pulling it downward.
Figure 4-10. Removing two No.3 screws and Tray Spacer
No. 1 Screws
Left Sub Frame
Left Housing Panel
No. 1 Screw
Waste Ink Absorber Tray Assy
Paper Eject Assy
Lower Paper Support Front
No3. Screws
Tray Spacer
To Next Page
Loading...
