Epson Stylus Color 1160 - PF Loop Scale Unit Assembling Procedure; Assembling the PF Loop Scale Unit

EPSON Stylus COLOR 860/1160 Revision C
Adjustment PF Loop scale unit assembling procedure 147
5.3 PF Loop scale unit assembling procedure
This section describes how to assemble the following parts
o PF Loop scale
o Base plate
o Double side adhesive tape
o Gear 76
This assembling procedure is required when the following parts is
replaced.
n Gear 76
n Loop Scale
For this assembling, following tool is required.
Table 5-1 Required Assembling Tool
5.3.1 Assembling the PF Loop scale unit
This section describes how to assemble the following parts.
o PF Loop scale
o Base plate
o Adhesive Tape
1. Set the AS Tool # 1051765 as following figure
2. Peel off the protection tape from the Base plate and set it on the AS
Tool # 1051765. The adhesive side should be faced to upward.
Figure 5-53. Setting the Base plate on the AS Tool # 1051765
No. Assembling Item assembling parts Required tool
1 Scale PF unit
Assembling tool
Stick the Loop scale
unit to the Gear 76
AS Tool code: 1051767
2 Mounting Plate scale
Attachment tool
Stick the Loop scale to
the base plat
AS Tool cod: 1051765
Base plate
AS Tool
#1051765
Protection tape
Adhesive side