Epson Stylus Color 1160 - Removing the CR Motor Assembly

EPSON Stylus COLOR 860/1160 Revision C
Disassembly and Assembly Disassembly Procedures 92
4.2.4.4 Removing the CR Motor Assembly
1. Remove the Upper Housing. (Refer to Section 4.2.1)
2) Using tweezers or a small screw driver, slide the CR Lock Lever to front
and release the CR Lock Lever from the CR unit. Then move the CR unit to
the center area of the CR shaft.
3) Loosen the CR Timing Belt by pushing the Driven Pulley Holder to right
using a screw driver, and remove the Timing Belt carefully from the pinion
gear on the CR motor. Refer to Figure 4-17.
Figure 4-17. Removing the Timing Belt
4) Remove two screws (No.1) while holding the CR motor and remove the CR
motor assembly. Refer to Figure 4-18.
Figure 4-18. Removing the CR Motor Assembly
CR Timing Belt
Driven Pulley
Holder
CAUTION
n When you remove the Timing Belt from the pinion gear on
CR motor, be careful not to damage the CR Encoder Slit
Plate.
n When you remove the CR motor through the hole in the Top
Frame, make sure the pinion gear does not hit the edge of
the hole.
Top Frame
CR Motor
No.1 Screws