Epson Stylus Color 1160 - Removing the PF Roller Assembly and Paper Eject Roller Assembly

EPSON Stylus COLOR 860/1160 Revision C
Disassembly and Assembly Disassembly Procedures 110
4.2.4.8 Removing the PF Roller Assembly and Paper Eject Roller Assembly
1. Remove the Upper Housing. (Refer to Section 4.2.1.)
2) Remove the Control Panel and Left Housing Panel.
3) Remove the Left Sub Frame.
4) Remove the ASF Assembly from the Printer Mechanism. (Refer to Section
4.2.4.6.)
5) Remove the CR Assembly. (Refer to Section 4.2.4.7.)
6) Remove three screws (No.1) securing the CR Unit Guide Plate to the Top
Frame.
Figure 4-56. Screws Securing the CR Unit Guide Plate
7) Remove the Upper Paper Guide Assemblies (Refer to “Note”) and one
Right Paper Guide Assembly, in the following direction, releasing their
Torsion Springs 117.6 from the hooks on the Top Frame. Refer to Figure
4-57
n Upper Paper Guide Assemblies: Remove them backward.
n Right Upper Paper Guide Assembly: Remove it forward.
NOTE: The number of Upper Paper Guide Assemblies attached to each model
varies as shown below:
Stylus COLOR 860: 5 pieces
Stylus COLOR 1160: 8 pieces
Figure 4-57. Removing the Upper Paper Guide Assembly
8) Stylus COLOR 860: Slide the Left Paper Guide to the left and remove it,
releasing one hook from the Top Frame. Refer to Figure 4-58.
Stylus COLOR 1160: The Left Upper Paper Guide Assy is not assembled.
Figure 4-58. Removing the Left Paper Guide
Left Side of the Printer Mechanism
No.1 Screw
Right Side of the Printer Mechanism
CR unit Guide Plate
No.1 Screws
Right Upper Paper
Guide Assy.
Back view of
the Printer
Front view of
the Printer
Upper Paper
Guide Assy.
Torsion Spring 117.6
One hook fixing the
Left Paper Guide
Left Paper Guide