Epson Stylus Color 1160 - Eeprom Address Map

EPSON Stylus COLOR 860/1160 Revision C
Appendix Connector Summary 164
7.1.2 EEPROM ADDRESS MAP
This section provides EEPROM address map for the Stylus Color 860/1100.
Table 7-12. EEPROM Address Map
Address Explanation Settings
QPIT
Settings
Factory
Settings
00H
Password
0FH -
01H 5AH -
02H
EEPROM mapping
revision
42H -
03H Reserved 00H -
04H Interface selection
0: Auto 1: Parallel
3: USB
00H 00H*2
05H Interface time-out
0 to 255
(by second, value of 0
means 10 seconds)
0AH 0AH
06H Compatibility speed
0: Fast 1: Slow
2: Special-1 3: Special-2
00H 00H
07H ECP speed *
a
0: Fast 1: Slow 00H 00H
08H IEEE1284.4 for Parallel
0: Auto 1: On
2: Off
00H 01H
09H IEEE1284.4 for USB
0: Auto 1: On
2: Off
00H 01H
0AH I/F Control flags
bit1: ECP mode
(0=Off, 1=On) *
b
bit0: IEEE1284 mode
(0=On, 1=Off) *
c
00H 00H
0BH Reserved 00H -
0CH Reserved 00H -
0DH Reserved 00H -
0EH Reserved 00H -
0FH Reserved 00H -
10H CPSI password 00H 00H
11H CPSI password 00H 00H
12H CPSI password 00H 00H
13H CPSI password 00H 00H
14H CPSI password 00H 00H
15H CPSI password 00H 00H
16H Print direction control
0: Bi-D 1: Uni-D
2: Auto
02H 02H
17H CG table 0: PC 437 1: PC 850 00H 00H
18H Font 0: Courier 00H 00H
19H Pitch 0: 10cpi 00H 00H
1AH
Auto LF, Network I/F
mode
bit1: Network I/F mode
(0=Off, 1=On)
bit0: Auto line feed
(0=Off), 1=On)
00H 00H
1BH Check mode control
bit7: Self test mode
bit6: Hex dump mode
00H 00H
1CH Reserved 00H -
1DH Reserved 00H -
1EH Reserved 00H -
1FH Reserved 00H -
20H
Bi-D Adjustment for
MultiShot (Bk)
-36<=n<=+36
(by 1/1440 inch)
00H (*1)
21H
Bi-D Adjustment for
6plVSD (Bk)
-36<=n<=+36
(by 1/1440 inch)
00H (*1)
Table 7-12. EEPROM Address Map (continued)
Address Explanation Settings
QPIT
Settings
Factory
Settings