Epson Stylus Color 1160 - Removing the ASF Assembly

EPSON Stylus COLOR 860/1160 Revision C
Disassembly and Assembly Disassembly Procedures 97
4.2.4.6 Removing the ASF Assembly
1. Remove the Upper Housing. (Refer to Section 4.2.1.)
2) Remove the following Cables from the cable hook in right side (viewed
from back) of the ASF Assembly.
- ASF HP Sensor Cable
- PF Motor Cable
3) Remove two screws (No.7 and ASF fixing screw) securing the ASF unit to
the Bottom Frame. Refer to Figure 4-29.
Figure 4-29. Removing the ASF Assembly (1)
4) Slide the ASF unit to the right (viewed from back) and pull it backward
carefully while holding up the Sub Paper Support Upper. Refer to Figure
4-30.
Figure 4-30. Removing the ASF Assembly (2)
ASF Fixing Screw
ASF Assembly
(Right Side)
No. 7 Screw
ASF Assembly
(Left Side)
Sub Paper Support Upper