Epson Stylus Color 1160 - Page 86

EPSON Stylus COLOR 860/1160 Revision C
Disassembly and Assembly Disassembly Procedures 86
Figure 4-8. Installing the Printhead
CHECK
POINT
n Make sure that the earth board is installed at the right corner
of the CR unit correctly. There are 2 pins used to determine
the location. Refer to Figure 4-8.
n When you install the printhead to the carriage, make sure
that the protrusion on the carriage side is placed in the U-
ditch of the printhead. Refer to Figure 4-8.
CAUTION
n Since the ink cartridge once taken out can not be used
again, be sure to install a new ink cartridge when you
return the printer to the user.
n Before packing the printer for transportation, make sure
new ink cartridges are installed and the carriage is locked
with the CR lock lever securely.
ADJUSTM ENT
REQUIRED
When you replace the printhead unit, perform the following
adjustments. (Refer to Chapter 5 for more details.):
1. Initial ink charge (Refer to Chapter 5/Section 5.2.3.9.)
2. Head Voltage ID Input (Refer to Chapter 5/Section 5.2.3.5.)
3. Head Angular Adjustment (Refer to Chapter 5/Section
5.2.3.6.)
4. Bi-D Adjustment (Chapter 5 /Section 5.2.3.7.)
Printhead Surface
Printhead Circuit Board
Carriage Assembly
Printhead
Nozzle Selector is included in the printhead.