EPSON Stylus COLOR 860/1160 Revision C
Disassembly and Assembly Disassembly Procedures 88
Figure 4-11. Installing the Spacer Tray
CAUTION
1. When installing the Waste Ink Absorber Tray Assembly,
make sure to fix it with the Spacer Tray in the left side of
the printer mechanism. Refer to Figure 4-11.
2. Be careful not to damage Loop Scale when removing the
Tray Spacer.
ADJUSTM ENT
REQUIRED
1. After the replacing the Waste Ink Absorber, perform the
following Panel Reset Function for ink overflow counter.
Turn on the Printer while holding the “Load/Eject
SW”+”Cleaning SW”, then hold “Cleaning SW” for 10
seconds.
Otherwise, perform the counter reset operation by using
the adjustment program. For details, Refer to Chapter 5
Section 5.2.3.11.
Spacer Tray
To Next Page
Loading...
