EPSON Stylus COLOR 860/1160 Revision C
Disassembly and Assembly Disassembly Procedures 113
Figure 4-65. Installing the Right Upper Paper Guide Assy.
CAUTION
n Do not bend or damage the PF Loop scale Plate during
disassembly and assembly.
n Do not touch the surface of the PF roller by hand.
n Be careful not to scratch the PF roller assembly during
disassembly and assembly, since its surface is specially
coated to improve paper feeding.
n Be careful not to damage the hook of the Paper Guide
Front during disassembly and assembly.
n Be careful not damage the fixing hook portion on the
Bushing 12. It is a very fragile part.
CHECK
POINT
n When the Right Upper Paper Guide Assembly is installed on
the Top Frame with a Torsion Spring 117.6, ensure that the
PE Detector Lever is set in the square cut off area in the
Right Upper Paper Guide. Insert the Right Upper Paper
Guide Assembly from the front so you can set the PE
Detector Lever in the square cut area in the Right Upper
Paper Guide. Refer to Figure 4-65.
n Make sure that the Torsion Spring 117.6 is set in the gutter
in the Upper Paper Guide Assembly.
n Make sure the PF Earth Spring is set in the gutter in the left
edge of the PF Roller.
n When replacing the PF Loop scale and Gear 76 with a new
one, you need to use the special tool to assemble them.
Refer to the Chapter 5 Section 5.3
ADJUSTM ENT
REQUIRED
n When the Gear 76 is removed or replaced with new one,
PF motor backlash adjustment is required. Refer to the
Chapter 5 (Section 5.2.2)
Back view of the Printer Mechanism
PE Detector Lever
Torsion Spring 117.6
Right Upper Paper
Guide Assembly
To Next Page
Loading...
