EPSON Stylus COLOR 860/1160 Revision C
Adjustment Adjustment 121
[Fixing Parallelism Adjustment Bushing]
13. Fix the right and left Parallelism adjustment bushings with screws.
(No.7 screw for each.)
When completing this adjustment, check the overlap amount of the
printhead and head cleaner.
1. Move the carriage next to the head cleaner and make sure that
overlap between the tip of the printhead and cleaner head is more
than 0.5 mm.
Figure 5-3. Overlap of Head Surface and the Cleaner Blade
2. Then, rotate the Combination Gear 13.5, 30 and return the head
cleaner under the Paper Eject Frame while releasing the Pump
Planetary Lever Fixing Guide.
To Next Page
Loading...
