Epson Stylus Color 1160 - Page 153

EPSON Stylus COLOR 860/1160 Revision C
Maintenance Overview 153
6
<Lubrication Point>
“SHAFT, PULLEY, DRIVEN”
See p. 152.
<Lubricant Type> G-26
<Lubrication Amount>
φ 1 x 1mm
7
<Lubrication Point>
Inside of “COMBINATION GEAR, 12,
22.4”
Use a dispenser to apply oil.
See p. 152.
<Lubricant Type> O-12
<Lubrication Amount>
Apply oil evenly to the inside of the
gear.
8
<Lubrication Point>
Inside of “COMBINATION GEAR, 14,
28”
Use a dispenser to apply oil.
See p. 152.
<Lubricant Type> O-12
<Lubrication Amount>
Apply oil evenly to the inside of the
gear.
9
<Lubrication Point>
Center of Pole C (2 places)
See p. 152.
<Lubricant Type> G-26
<Lubrication Amount>
φ 1 x 3mm
10
<Lubrication Point>
“FELT, D3.6”
Wipe off any oil leaking into the
motor side.
See p. 152.
<Lubricant Type> O-12
<Lubrication Amount>
Full (but not overfull)
Table 6-2. Lubrication Point (continued)
No. Standard Remarks
11
<Lubrication Point>
Groove of “ROLLER, PF”
See p. 152.<Lubricant Type> G-26
<Lubrication Amount>
φ 1 x 5mm
12
<Lubrication Point>
Contact point between “ROLLER,
EJECT” and “GROUND SPRING,
EJECT”
See p. 152.
<Lubricant Type> G-26
<Lubrication Amount>
φ 1 x 2mm
13
<Lubrication Point>
Bearing of “PAPER GUIDE, REAR”,
and contact point between “ROLLER,
PF” and the rotating gear of “Roller, PF
Unit”
Apply grease while rotating the
“Roller, PF Unit”.
See p. 153.
<Lubricant Type> G-26
<Lubrication Amount>
φ 1 x 1/2 turn
14
<Lubrication Point>
“PAPER GUIDE, FRONT” (3 places)
See p. 153.
<Lubricant Type> G-26
<Lubrication Amount>
φ 1 x 2mm (Roller Eject side)
φ 1 x 2mm (Roller Eject side)
φ 1 x 10mm (Roller PF side)
Table 6-2. Lubrication Point (continued)
No. Standard Remarks