Epson Stylus Color 1160 - Page 168

EPSON Stylus COLOR 860/1160 Revision C
Appendix Connector Summary 168
NOTE: *a: BUSY signal delay time from fall-edge of a -STB signal.
(Fast:Max, 1MB/s, Slow:Max, 600KB/s)
*b: Select IEEE1284 transfer mode. (ECP or Nibble)
*c: Enable or disable reverse transfer (when disabled, ignore
-SLIN signal).
*1: Adjusted at factory.
*2: Initialized after performed panel initialization of EEPROM.
*3: Initialized after performed panel initialization of the ink overflow
counter in EEPROM.
C2H
USB ID
00H (*1)
|||
D3 00H (*1)
D4
Reserved
00H -
|||
D7H 00H -
D8H
Custom EEPROM sub
number
00H 00H
D9H 00H 00H
DAH 00H 00H
DBH 00H 00H
DCH Panel mask function
bit7: Entry Self-Test
bit6: Entry Hex-Dump
bit5: Extended settings
bit4: Reserved
bit3: Reserved
bit2: Cleaning
bit1: Replace I/C
bit0: Load/Eject
00H 00H
DDH
Reserved
00H -
DEH 00H -
DFH 00H -
E0H Market ID 0:STD 2:Custom 00H 00H
E1H Reserved 00H -
E2H
Model Name
00H -
|||
FFH 00H -
Table 7-12. EEPROM Address Map (continued)
Address Explanation Settings
QPIT
Settings
Factory
Settings