Epson Stylus Photo R2000s Series - Page 109

EPSON Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series Revision I
Disassembly And Assembly Disassembling the Printer Mechanism 109
9. Remove the two C.B.S. M3 x 6 screws that secure the two Guide Roller LDs.
10. Gently pull the LD Roller Shaft to the rear of the printer, and remove the Guide
Roller LDs.
Figure 4-95. Removing the Guide Roller LD
11. Remove the three C.B.S. (P4) M3 x 8 screws that secure the ASF Assy, and
remove the ASF Assy from the Printer Mechanism.
Figure 4-96. Removing the ASF Assy
Referring to Figure 4-93, correctly route each of the cables and
FFCs.
C H E C K
P O I N T
When only removing the ASF Assy, you do not need to perform
"5.2.5 ASF Guide Roller LDs Position Adjustment (p161)". In that
case, mark the installing positions of the Guide Roller LDs before
removing them, and make sure to align the markings when
installing the Guide Roller LDs.
Figure 4-94. Marking Position
Front
Face
2) C.B.S. M3x6
(8±1 kgf.cm)
Guide pin
Tab
LD Roller Shaft
Guide Roller LD
Guide Roller LD
Align the guide pins and tabs on the Guide Roller LDs with the
positioning holes on the Main Frame. (Refer to Figure 4-95.)
2
1
6) C.B.S. (P4) M3x8
(6±1 kgf.cm)
ASF Assy
6) C.B.S. (P4) M3x8
(6±1 kgf.cm)
34