Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series Revision I
SC-P400 Series Adjustment 228
Figure 9-18. Starting the Color Measurement
Table 9-12. Troubleshooting when the measurement fails
Presumable Cause Major Troubleshooting
The adjustment of the printer may
be insufficient.
After the adjustments that must be done after parts
replacement are all complete, perform the
measurement again.
The media has deteriorated and
discolored.
The media was stored in bad
conditions and damaged.
Use new Ultra Premium Presentation Paper Matte
Enhanced Matte Paper or Archival Matte Paper.
The color or contamination of the
backing may be interfering.
When using the backing board: remove any
contamination on the backing board, and then stack
two color charts over on each other and perform the
measurement.
Measurement without a backing board: Stack the
color chart over on each other on blank (white)
Premium Glossy Photo Paper and perform the
measurement.
Wrong row/wrong measuring
direction
See Figure 9-16 and Table 9-11 and confirm the
current row to be measured and the measuring
direction are correct.
Measuring at an angle Align the scale with the chart correctly again, and then
slide the calibrator in parallel to the row to be
measured on the patches.
To Next Page
Loading...
