Epson Stylus Pro 9900 - Page 204

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 204
Confidential
4.4.2.2 IC Cover (L/R)
1. Turn the printer ON.
2. Press the [Ink Cover Open] button on the Control Panel to open the IC Cover R.
3. Turn the printer OFF.
4. Pull the IC Cover downwards to disconnect the joints to remove the IC Cover R.
Figure 4-16. Removing the IC Cover (L/R)
C H E C K
P O I N T
Basically you can remove this part on the left and the one on the
right in the same way. Therefore this section describes the way to
remove the one on the right only.
C H E C K
P O I N T
In the case that the IC Cover cannot be opened by the Control
Panel operation for some reasons, follow the procedure of 4.4.1.2
Unlocking the IC Cover manually (p202) to open the IC Cover.
Joints
IC Cover R