Epson Stylus Pro 9900 - Page 205

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 205
Confidential
4.4.2.3 IC Shaft Cover (L/R)
1. Remove the IC Cover R. (p204)
2. Remove the two screws that secure the IC Shaft Cover R.
A) Silver, Phillips, Bind machine screw M3x8: two pieces
3. Remove the IC Shaft Cover R.
Figure 4-17. Removing the IC Shaft Cover (L/R)
C H E C K
P O I N T
Basically you can remove this part on the left and the one on the
right in the same way. Therefore this section describes the way to
remove the one on the right only.
A
IC Shaft Cover R