Epson Stylus Pro 9900 - Page 206

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 206
Confidential
4.4.2.4 IC Cover (L/R) & IC Shaft Cover (L/R)
1. Turn the printer ON.
2. Press the [Ink Cover Open] button on the Control Panel to open the IC Cover R.
3. Turn the printer OFF.
4. Remove the two screws that secure the IC Shaft Cover R.
A) Silver, Phillips, Bind machine screw M3x8: two pieces
5. Remove the IC Cover R and the IC Shaft Cover R.
Figure 4-18. Removing the IC Cover (L/R) & IC Shaft Cover (L/R)
C H E C K
P O I N T
Basically you can remove this part on the left and the one on the
right in the same way. Therefore this section describes the way to
remove the one on the right only.
C H E C K
P O I N T
In the case that the IC Cover cannot be opened by the Control
Panel operation for some reasons, follow the procedure of 4.4.1.2
Unlocking the IC Cover manually (p202) to open the IC Cover.
C H E C K
P O I N T
When removing the screws, hold up the IC Cover to insert a driver.
IC Shaft Cover R
IC Cover R
A