Epson Stylus Pro 9900 - Page 215

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 215
Confidential
4.4.2.11 Spindle Cover R
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Open the Roll Cover Assy until the screw that secures the Spindle Cover R can be
seen.
6. Remove the three screws that secure the Spindle Cover R.
A) Silver, Phillips, Bind P-tite M4x12: two pieces
B) Silver, Phillips, Bind S-tite with S.W & P.W. M4x12: one piece
7. Remove the Spindle Cover R.
Figure 4-28. Removing the screws (inside)
Figure 4-29. Removing the Spindle Cover R
A
A
Roll Cover Assy
Spindle Cover R
Open it until
this can be seen.
B
Spindle Cover R