Epson Stylus Pro 9900 - Page 221

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 221
Confidential
4.4.2.16 Front Cover Sensor R
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Remove the Rear Cover. (p220)
6. Remove the Mid-Front Cover. (p257)
7. Remove the Front Cover (Lower). (p261)
8. Disconnect the connector (CN21) on the Main Board Assy.
9. Release the cable from the cable tie, clamp and the saddle. See Figure 4-36.
10. Pull out the harness from the hole on the Main Frame. See Figure 4-37.
11. Release the cable from the two clamps. See Figure 4-37.
Figure 4-36. Releasing the harnesses (rear)
Figure 4-37. Releasing the harnesses (front)
CN21
- As seen from the rear -
Clamp
Saddle
Main Board Assy
Cable tie
- As seen from the front -
Clamps
Hole