Epson Stylus Pro 9900 - Page 227

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 227
Confidential
8. Disconnect the two connectors (CN408, CN409) on the Ink Holder Board Assy L.
9. Release the harness from the two hooks and the tape. See Figure 4-46.
10. Remove the two screws, and remove the Cartridge Cover Sensor L.
C) Black, Phillips, Bind P-tite M3x10: two pieces
Figure 4-46. Removing the Cartridge Cover Sensor L
C H E C K
P O I N T
When removing the screws in the next step, use a stubby driver or a
ratchet screw driver.
C
- Left side -
Ink Holder Board Assy L
Connectors
Hooks
Cartridge Cover Sensor L
Tape